Processing Method For Failure Of Servo Machining Center Of CNC Machining2

As a Telescope Parts Precision Machining Wholesaler, we continue to share with you how to handle the failure of the CNC machining center servo system.

4. Overload alarm, the cause of the overload alarm is that the CNC mechanical load of the machining center is abnormal, or the upper limit of the motor current on the speed control unit is set too low. The permanent magnet on the permanent magnet motor will also cause an overload alarm. If the motor of the machining center without the brake is unloaded, it will be difficult to turn the shaft or rotate the shaft when it is unloaded, which means that the permanent magnet is completely detached.

5. The fuse on the CNC speed control unit of the machining center is blown or the circuit breaker trips.

6. The current is large, causing the machine tool to alarm. A large current alarm occurs. There are two possibilities under normal circumstances, that is, the large current alarm caused by the damage and short circuit of the power drive component on the CNC speed control unit of the machining center.

7. High voltage will also cause machine tool alarms. There are generally three possibilities for high voltage alarms. It may be that the CNC input voltage of the machining center exceeds 10% of the rated value, or the insulation performance of the servo motor is degraded, or The high voltage caused by the line of the machining center operating speed control unit.

Our company provides CNC Drill Holes Service. Welcome to contact us.